User manual

ManualsBrandsBAAS ManualsBattery Charging & MaintenanceAutomatic charger 12 V 2 A

Technical data

Battery type switchable

A) 12V lead batteries

(acid, gel, AGM, EXIDE, Hawker)

B) Li-Ion batteries

With CAN-bus-interface

Current: max. 2A (autom.)

Voltage: 12V

Charging voltages: 14,3 V

Recommended for: 1,2 bis 100 Ah

Surrounding temperature: 5 – 50° C

Reverse polarity and short circuit protection

Dimensions: 165 x 82 x 47 mm / 475 g

Usage of the product

1. Battery connection:

Black clamp to negative terminal (–), red clamp to

positive terminal (+).

When you want to connect to a battery installed in

a vehicle, please switch ignition off. Control and ﬁll

up battery water eventually, before charging.

2. Connection to 230V AC.

Green LED „Power“ will shine. Red LED only

shines for disconnection. Disconnect the battery

from the charger immediately, to avoid damages.

3. Choose proper charging voltage

Press the pushbutton for Pb or Li.

• Keep away easy ammable products and water

away from the charger.

• Only for use in dry and proper kept rooms only.

Make sure to have enough air supply.

• Avoid battery deep discharged and note battery

manufacturers regulations

• Make sure not to have open re and glimmers

closed to charged batteries (danger of explosion)

Warranty

We grant of 2 year for BA201. It includes free of

charge repair of defects, which result clearly from

incorrect materials or manufacturing mistakes.

No warranty by changing and own repairing of the

product, using with wrong currents + voltages.

BA201 is a modern, intelligent battery charging and diagnostic tester for

12V lead-acid batteries, such as gel batteries, Exide, AGM, Hawker, Litihium,

Micro-ﬂow and acid batteries. It works with characteristic controlled

charging technology, allows for optimal charging and battery maintenan-

ce. The software constantly monitors the complete functions and controls

depending on the state the correct charging procedure.

MANUAL BA201

CE mark and conformity

We, the manufacturer (BAAS bike parts) hereby declare that this equipment is in compliance with the

essential requirements and other relevant provisions of Directive 2014/30/EU

and 2014/35/EU. CE conformance has been certiﬁed – the relevant records are in the hands of the

manufacturer: BAAS bike parts | Burgstr. 15 | D-74232 Abstatt

Anleitung_BA201.indd 10 16.10.17 20:13