User's Manual
22 This product is only designed to work at an ambient
temperature of up to 45°C.
23 Ensure that the wall socket is near the equipment and
easily accessible.
24 The product’s power supply must only be used indoors.
It has NOT been designed for use outdoors, on boats or
recreational vehicles.
25 To reduce the risk of re or electric shock, do not expose
the product to rain or moisture.
26 This product contains Lithium-Ion batteries, if misused
or damaged this can become a hazard and is at risk of
explosion.
27 Do not handle the product should the battery leak.
28 Do not incinerate the product. The internal battery could
explode causing injury or death.
29 Do not attempt to access or replace the product’s
battery, the battery is internal and not user serviceable.
30 Refer to the product manual for information on battery
care.
31 Turn off the product before boarding aircraft.
32 Do not position or store the product or accessories on or
near a vehicle air bag, should the airbag exploded there is
a risk of injury.
33 Dispose of this product in accordance with local
regulations. This product must not be disposed off with
regular household waste.
34 Do not allow children to use this product without
supervision.
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
CAUTION:
Any changes or modications not expressly approved by the
grantee of this device could void the user’s authority to
operate the equipment.
Labeling requirements
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
RF exposure warning
This equipment must be installed and operated in accordance
with provided instructions and the antenna(s) used for this
transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or
transmitter. End-users and installers must be provide with
antenna installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
Canada, Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian
ICES-003 and RSS-210. Operation is subject to the following
two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below
the Industry Canada (IC) radio frequency exposure limits. The
Wireless Device should be used in such a manner such that
the potential for human contact during normal operation is
minimized.
This device has also been evaluated and shown compliant
with the IC RF Exposure limits under mobile exposure
conditions. (antennas are greater than 20cm from a person’s
body).