BT7513 DOUBLE ARM FLAT SCREEN WALL MOUNT WITH TILT & SWIVEL INSTALLATION GUIDE & PARTS LIST This Pack Contains 1 Fiat Screen Mount [| rer PLEASE KEEP THIS FOR FUTURE REFERENCE FEATURES + Designed for screens up to 28° (71cm) / 15kg + Alts screens with VASE mounting patterns: 75x 75mm and 100 x 100mm *» Mounts screen 85mm 467mm from wall = Easy +17° 1-10" tilt adjustment + Arm features three swivel points: 180°, 360° & 240° «360° screen rotation for easy leveling and to allow screen to ba mounted In landscap
INSTALLATION SAFETY INSTRUCTIONS CAUTION * This mount is intended for use only with the maximum weights indicated. Use with flat screens heavier than the maximum indicated may result in instability causing possible injury. Do not attempt to install this product until all instructions and wakings have been read and property understood Please keep theses Instructions for future reference. Please check careful to make sure there are no missing or defective parts defective parts must never be used.
WALL PLATE EXTENSION ARM 1 TILT PLATE INTERFACE PLATE M8 x 12mm SCREW WASHER 7 8 8 COVER PLATE CLIPLOGIC™ CABLE MANAGEMENT CLIP 4mm SECURITY HEX KEY 10 | 5mm SECURITY HEX KEY 1 wl m|n|n| M4 x 12mm SECURITY SCREW Al | M5.
INSTALLATION INSTRUCTIONS 1 Fix wall plate to the wall using ons of the following methods. i. Brick / concrete walls.
all Secure in position and adjust tilt. & To fix extension arm position, tighten hex screws on arm at wall plate, central pivot and tilt bracket.
Optional Cliplogic™ cable management clip MAXIMUM CABLE THICKNESS ~N MAX @12.
