Specifications

ESP-13U Specification V1.0

XIX

OEM/Integrators Installation Manual

Important Notice to OEM integrators

INTEGRATION INSTRUCTIONS

FCC rules

The ESP-13U is an Wi-Fi Module with frequency hopping. It operates on the 2400

~2500 MHz band and, therefore, is within U.S. FCC part 15.247 standard.

Modular installation instruction

1,ESP-13U Integrates high-speed GPIO and peripheral interface. Please pay

attention to the installation direction (pin direction).

2,Antenna could not be in no-load state when module is working. During debugging,

it is suggested to add 50 ohms load to the antenna port to avoid damage or

performance degradation of the module under long-time no-load condition.

3,When the module needs to output 15dBm or more power, it needs a voltage supply

of 3.6V or more to achieve the expected output power.

4,When working at full load, it is recommended that the entire bottom surface

of the module be attached to the housing or heat dissipation plate, and it is

not recommended to conduct heat dissipation through air or screw column heat

conduction.

5,UART1 and UART2 are serial ports with the same priority. The port which receives

commands returns information.

Trace antenna designs

Not Applicable

Antennas

The ESP-13U is an BT Module beams signals and communicates with its antenna, which

is FPCB Antenna. The FPCB Antenna gain is 0.5dBi

LABEL OF THE END PRODUCT

The final end product must be labeled in a visible area with the following：

Host must Contains FCC ID: 2ATPO-ESP13U. If the size of the end product is larger

than 8x10cm, then the following FCC part 15.19 statement has to also be available

on the label: This device complies with Part 15 of FCC rules. Operation is subject

to the following two conditions:

(1) this device may not cause harmful interference and

(2) this device must accept any interference received, including interference

that may cause undesired operation.