Product Info

B&R wireless board "RFM-2-NF"
Standard Documentation for Radio Equipment Certification
Packaging-Marking
Copyright © B&R - Subject to modification
Description Module RFM-2-NF_1_Version 1.4.docx
Tuesday, April 9, 2019 2:25:00
PM
13/17
8.3 Packaging-Marking
This section describes the necessary information on the packaging (sticker) of a B&R end-device that
contains an RFM-2-NF but also for the packaging (sticker) of the B&R wireless board RFM-2-NF when
shipped for retrofit or as spare part. In case of retrofitting the labeling requirements of an end-device
must be taken into account.
Domain/Country
Marking
Remarks
EU
None
USA
This device contains license-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada’s license-exempt RSS(s). and part 15 of the FCC Rules. Oper-
ation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the
device.
“GENERAL GUIDELINES FOR
LABELING AND OTHER IN-
FORMATION REQUIRED TO
BE PROVIDED TO USERS”
Clause 5 and Appendix A
Canada
N/A
Japan
None
China
None
8.4 User Manual Information
This section provides regulatory information that have to be addressed to the end user.
Domain/Country
Information
Remarks
EU
This product is in conformity with the protection requirements
of the EU Council Directive 2014/53/EU.
USA
This device complies with Part 15 of the FCC rules. Operation
is subjected to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found comply with
the limits of Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a commercial envi-
ronment. This equipment generates, uses and can radiate ra-
dio frequency energy and, if not installed and used in accord-
ance with the instructions, may cause harmful interference to
radio communications. Operation of this equipment in a resi-
dent area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own
expense.
Section 15.21
Section 15.105
(a)
Canada
This device contains license-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Develop-
ment Canada’s license-exempt RSS(s). Operation is subject
to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference
received, including interference that may cause undesired op-
eration.
L’émetteur/récepteur exempt de licence contenu dans le pré-
sent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appa-
reils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire
RSS-Gen
issue 5
Clause 8.4