Integration Guide

B&R wireless board "RFM-2-NF"
Integration Guide
User manual information
Copyright © B&R - Subject to change without notice
Integration Guide RFM-2-NF_Version 1.0.docx
April 4, 2019
6/9
2.7 User manual information
The user manual should contain the following information:
Domain/Country
Information
EU
This product is in conformity with the protection requirements of the EU Council
Directive 2014/53/EU.
USA
This device complies with Part 15 of the FCC rules. Operation is subjected to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found comply with the limits of
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. Operation of
this equipment in a resident area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
Canada
This device contains license-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference re-
ceived, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux condi-
tions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisa-
teur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
2.8 Additional aspects
The B&R wireless board has to be part of the bill of material of the complete end device and must be
identifiable by the serial number of the complete end device.