Integration Guide

ManualsBrandsB&R Industrial Automation ManualsElectronicsB&R wireless board

B&R wireless board "RFM-2-NF"

Integration Guide

List of applicable guidelines,

standards, rules

Integration Guide RFM-2-NF_Version 1.0.docx

April 4, 2019

5/9

2.2 List of applicable guidelines, standards, rules

Domain/country

References

EU domain

Radio Equipment Directive 2014/53/EU

FCC Domain

FCC Rules and Regulations Part 15, Subpart C - Intentional Radiators

Part 15, Subpart C, Section 15.203 Antenna requirement

Part 15, Subpart C, Section 15.204 External radio frequency power amplifiers and

antenna modifications

Part 15, Subpart C, Section 15.207 Conducted limits

Part 15, Subpart C, Section 15.209 Radiated emission limits, general requirements

Part 15, Subpart C, Section 15.215 Additional provisions to the general radiated

emission limitations

Part 15, Subpart C, Section 15.225 Operation within the band 13.110 - 14.010

MHz

FCC Rules and Regulations Part 1, Subpart I - Procedures Implementing the

National Environmental Policy Act of 1969

Part 1, Subpart I, Section 1.1310 Radiofrequency radiation exposure limits

Part 1, Subpart 2, Section 2.1093 Radiofrequency radiation exposure evaluation:

portable device

2.3 Specific operational conditions

There are no specific use conditions that are applicable to the B&R wireless board RFM-2-NF when inte-

grated into a host.

2.4 Modifications

Any modification of the B&R wireless board RFM-2-NF require new approvals. Host manufacturers are

not allowed to modify the B&R wireless board RFM-2-NF or its components.

2.5 RF-Exposure condition

Because of the low power nature of the B&R wireless board RFM-2-NF, there are no application condi-

tions or limitations for host product manufacturer to use the module. So no additional RF statement need-

ed for the host product manufacturer to put in the manual.

2.6 Label and compliance information

The host and/or the complete end-device must contains following label or optional engraved marking or

laser marking for the North America-Domain and a CE for the EU-Domain.

Figure 2: Layout proposal marking of host for the North American Domain

This device contains license-exempt transmitter(s)/receiver(s) that comply

with Innovation, Science and Economic Development Canada’s license-

exempt RSS(s). and part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause interference, and

(2) this device must accept any interference, including

interference that may cause undesired operation of the device.

Changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment

contains FCC ID: 2ADFV-RFM-2-NF

contains IC: 12444A-RFM2NF