User's Manual

Product Brief – Airborne SDIO/SPI 802.11b/g Radio Quatech, Inc.
846-8310-240 June 2010 28
12.0 Certification & Regulatory Approvals
The unit complies with the following agency approvals:
Table 16 - Regulatory Approvals
Country
Standard
Status
North America
(US & Canada)
FCC Part 15, Sec. 15.107, 15.109, 15.207, 15.209,
15.247
RSS-210
Modular Approval
Granted
Europe
EN60950 inc. A1, A2, A3, A4
ETSI EN 300 328 Part 1 V1.2.2 (2000-07)
ETSI EN 300 328 Part 2 V1.1.1 (2000-07)
ETSI EN 301 893 V1.2.1 (2002-07)
ETSI EN 301 489-1 V1.4.1 (2002-08)
ETSI EN 301 489-17 V1.4.1 (2000-09)
Pending
Japan
ARIB STD-T71 v1.0, 14 (Dec 2000)
ARIB RCR STD-T33 (June 19, 1997)
ARIB STD-T66 v2.0 (March 28, 2002)
Pending
12.1 FCC Statement
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for assistance.
12.2 SAR Statement
The WLRG-RA-DP601 has been tested for body-worn Specific Absorption Rate
(SAR) compliance. The FCC has established detailed SAR requirements and has
established that these requirements have been met while the WLRG-RA-DP601
was installed in a host representative host system.