User's Manual
Table Of Contents
- _
- Figures
- Tables
- _
- Introduction
- _
- Making connections
- _
- Enabling Wi-Fi Device Servers
- Installing the device drivers
- _
- Configuring the SDS using the Web interface
- _
- Troubleshooting and Maintaining an SDS
- Appendix A
- Appendix B
- Appendix C
Quatech SDS User’s Manual Enabling Wi-Fi Device Servers
Step Procedure Description
Note: The Channel setting is only used in Ad
hoc mode. In Infrastructure mode, the AP
determines the channel.
Step 11 Press Submit to configure the SDS with
your settings.
The IP Address Update successful screen
displays.
Step 12 Reset the SDS. Click on the link to perform a remote reset,
and then press Reset.
Step 13 Remove the Ethernet cable from the SDS
during the reset process.
B
e sure to remove the Ethernet cable before
the reset process is finished.
Step 14 Leaving the Ethernet port unconnected,
perform the procedure shown in
Installing
the device drivers
starting on page 16,
skipping
□ Step 6.
When you are finished, you are ready to
install your wireless SDS in its final
location. For details on connecting your
wireless SDS to a serial device, see
Making connections starting on page 13,
skipping
□ Step 3.
March 2005 940-0183-151 Page 15