User's Manual
Table Of Contents
- T
- Table of contents
- I
- Introduction
- M
- Making connections
- E
- Enabling Wi-Fi Device Servers
- Installing the device drivers
- C
- Configuring the SDS using the Web interface
- T
- Troubleshooting and Maintaining an SDS
- Appendix A
- Appendix B
- Appendix C
Configuring the SDS using a We b inte rface Quate ch SDS Use r’s Manual
Page 74 Re v 1 .5 0 (3/1 3 /20 0 5)
Figure 68 - Firmware Upgrade screen
Step Procedure Description
# Step 1 Browse to the location with the revised
firmware file.
Most of Quatech’s device drivers are
available from our Web site.
# Step 2 Press Send File. The Remote Reset screen displays.
Figure 69 - Remote Reset
Step Procedure Description
# Step 3 Press Reset to reset your SDS. The SDS must be reset to implement the
new firmware.
Contacting Quatech
Step Procedure Description
# Step 1 From the Home screen, select Contact Us. The Contact Us screen displays.
Figure 70 - Contact Us screen
Note: Only SDS devices with a
firmware revision level of 5.0
and above can support SNMP.
Determine the revision level of
an SDS (check the bottom of
the Home page in the Web-based
interface) before upgrading the
firmware.