User's Manual
Table Of Contents
- T
- Table of contents
- I
- Introduction
- M
- Making connections
- E
- Enabling Wi-Fi Device Servers
- Installing the device drivers
- C
- Configuring the SDS using the Web interface
- T
- Troubleshooting and Maintaining an SDS
- Appendix A
- Appendix B
- Appendix C
Quate c h SDS Us e r’s Manual Configuring the SDS using a We b inte rface
Re v 1 .5 0 (3 /1 3/2 00 5 ) Page 51
Step Procedure Description
! Clear the check box to allow the SDS
to accept packets only from the host
you specify in the Management Host/
Trap Destination configuration.
# Step 5
Press Submit to configure the SDS with
your settings.
The SNMP Update Successful screen
displays. You must reset the SDS for
your changes to take effect.
If you press the browser’s Back button,
your original settings remain unchanged.
Note: Press the browser’s Back button to
make no changes to the original settings.
Figure 49 - SNMP Address Update Successful screen
Step Procedure Description
# Step 6 Click on the link to reset the SDS. The Remote Reset screen displays.
Figure 50 - Remote Reset screen
Step Procedure Description
# Step 7
Press Reset to activate your settings. The SDS is now resetting screen displays.
Figure 51 - SDS is now resetting screen