User's Manual
Table Of Contents
- T
- Table of contents
- I
- Introduction
- M
- Making connections
- E
- Enabling Wi-Fi Device Servers
- Installing the device drivers
- C
- Configuring the SDS using the Web interface
- T
- Troubleshooting and Maintaining an SDS
- Appendix A
- Appendix B
- Appendix C
Ins talling the de vice drive rs Quate c h SDS Use r’s Manual
Page 34 Re v 1 .5 0 (3/1 3 /20 0 5)
Figure 30 - TCP/ IP Network Configuration Parameters screen
Step Procedure Description
Step 38 If you are satisfied with the parameters,
press Next to continue.
If you are not satisfied, press Change
Properties to change the TCP/IP
properties.
The Rerun network connectivity test pop-
up box displays.
Continue with □ Step 39.
The Internet Protocol (TCP/IP)
Properties dialog box displays.
Go to □ Step 32.
Figure 31 - Rerun network connectivity test pop-up box
Step Procedure Description
Step 39 Press OK. The Network Connectivity Test screen
displays. Go to □ Step 14.
Figure 30 shows the TCP/IP
network configuration parameters
including the following:
! Addre ss type
! IP Addre ss
! Subne t mask
! Default gateway
Figure 31 shows the Rerun
network connectivity test pop-
up box.