User's Manual

The Radenso Pro-M windshield mount allows a firm and secure installation of the radar
detector at the windshield of your vehicle. Locate an area at the windshield that enables an
unobtrusive installation with clear view to the road
ahead.
1. Place the nipple of the suction cups in the large hole of
the bracket and
pull the suction cup into the small Rubber Damper
hole to secure them. Push the rubber damper
into the hole in the middle of the bracket.
2. Attach the windshield mount to the desired area of the windshield. Make sure it is in a level
position parallel to the road ahead. To adjust the angle if necessary, gently push or pull on the
bracket to bend it. DO NOT use the detector to bend the
bracket.
3. Insert the windshield mount into the slot at the front of
the detector until it is locked in position.
For firm and secure adhesion to the windshield, clean the windshield and suction cups before
usar installing.
4. Plug the small end of the power cable into the detector (located on the left side) and the large
end into your vehicle’s 12V ACC socket.
5. To remove Radenso Pro-M from the windshield press the release button on top of the unit
and slide the unit off the mount.
Left button: MENU / ON-OFF.
Short press: You will enter into setup menu. During an alert pressing the button will mute the
volume. The next alarm will be reported again in the standard volume.
Long press: Turn ON / OFF Radenso Pro-M.
Short press: You can change the brightness of the display -> Bright -> Dim -> Smart Dark -> Full
Dark.
Bright: Brightest display setting.
Dim: Slightly dimmed display.