Installation Manual

Radar Detector Radenso RC-M
G) LASER SENSORS
Laser sensors can be mounted on the front of the vehicle in the front grill, above the bumper or
in the rear of the vehicle. Be extra careful to not damage the cable, sensor or connector during
installation, as it will terminate your warranty. To ensure better looks of your vehicle we
recommend to use plexiglass „Perspex” to hide the sensors. For more information about the
glass please contact your distributor.
To drive the cables to the fuse box, please use the original cable pass. In case there is not
enough space there you will need to drill an extra hole for the connector and the cable. Please
be extra careful again to not damage cables or other car installation. After you finish the cable
installation, you should seal the gap using silicon or other fillings to prevent water and humidity
entering the vehicle. Check the cable if its long enough to reach the desired destination. When
you have connected together with a cable from the sensor (1m long) with the control box cable
(4m long) make sure to use waterproofing duck tape. You can use hot air or lighter to make the
seal even tighter. Place the sensors so that they have a clear view to the front or the rear using
the included holders and double sided duck tape. If necessary, you can bend the holder into
required position. Make sure that the sensor is held firmly and can withstand vibrations caused
by cruising and is still in horizontal front/rear facing position.