Installation Manual

Radar Detector Radenso RC-M
A) Radenso RC-M CONTROL UNIT
The control Unit is usually placed in a fuse box, space above pedals, using stripping tape to
wires in your car, or using double-sided duck tape. Connecting individual components is obvious
thanks to writing on the control box. All can be easily done thanks to plug-in connectors. When
connecting individual accessories please mind the plug you are trying to connect the cables
into, as they must be connected to a correct plug, in case it isn't so the RADENSO RC-M might
not work properly or be permanently damaged. Also be mindful of placing the control unit so that
the speaker on top of it is placed facing in free space.
B) DISPLAY
The display is usually placed in vehicle cabin on your consideration using the double-sided sticky
tapes, or magnetic tape. We recommend placing the display in an easily accessible area.
C) GPS ANTENNA
Place the GPS antenna using double-sided duck tape to a place where the antenna can see the
sky. Ideally on the dashboard of your car. If you are placing it under the dashboard, make sure
that the antenna is not covered by any metal objects. you can check the antennas functionality
on the display. If the GPS icon glows constantly, it means it works as intended, in case it's
blinking it means that it can not find a GPS signal. The first time it can take 1-5 minutes for the
GPS to connect.