Instruction manual

5
Safety information
Be sure to read and observe the following instruc-
tions!
The device has been designed using state of the art technolo-
gies and it complies with the applicable safety regulations.
When operating the device, certain conditions may neverthe-
less lead to danger for the operator or damage to the device.
Caution!
Commissioning may only be carried out by trained experts.
Whenever it is likely that protection has been impaired, the
device shall be made inoperative and secured against unintend-
ed operation.
The protection is likely to be impaired if, for example:
• the device shows visible damage
• the device fails to perform the intended measurements
• after prolonged storage at temperatures above 70 °C
• after severe transport stresses
Before recommissioning the device, a professional routine test
in accordance with EN 61010-1 must be performed. This test
should be carried out by the manufacturer.
Caution!
Before commissioning it must be proved that the device may
be connected with other equipment.
70098_E_CI7100_2XH.QXD 27.07.2005 9:27 Uhr Seite 5