Instruction manual

Transmitter Cond Ind 7100e/2(X)

Configuration

In the Configuration mode you set the device parameters.

Activate with conf

Enter passcode “1200”*.

Edit parameter with  and ,

confirm/continue with enter.

(End with conf, then enter.)

During configuration the transmitter

remains in the Hold mode for

reasons of safety. The loop current

is frozen (at its last value or at a

preset fixed value, depending on

the configuration), Sensoface is off,

mode indicator “Configuration” is

on.

Activate

Hold

Input errors

The configuration parameters are

checked during the input. In the case

of an incorrect input ”Err” is dis-

played for approx. 3 sec. The incor-

rect parameters cannot be stored.

Input must be repeated.

End End with conf. The measured value

and Hold are displayed alternately,

“enter” flashes. Press enter to end

the Hold mode. The measured value

is displayed. The output current

remains frozen for another 20 s

(HOLD icon on, “hourglass” flashes).

HOLD icon

* Factory setting, for passcode editing, see Pg 56

70098_E_CI7100_2XH.QXD 27.07.2005 9:27 Uhr Seite 34