Specifications

8 BK Radio
To enter a Digital Code Guard value press
the [#] key, causing the letter ‘D’ to appear
followed by three zeros. Enter the desired
digital code using keys 0 thru 7 (keys 8 & 9
do not respond). See "Digital Code Guard
Values" on page 23 of this manual. Pressing
the [PRI] key after the three-digit code has
been entered allows the digital code to be
inverted. When the displayed value is
correct, press the [ENT] key to store the
Code Guard value and automatically
advance to the next field.
4. Transmit Frequency
After the RX GUARD is set, the ‘TX
FREQUENCY’ field appears. This is the
transmitter frequency for Channel 1.
If it is correct, press the [FCN] key to
advance to the next field.
If you wish to change it, press the [CLR] key
followed by the frequency in MHz then [ENT]
to store the new frequency and automatically
advance to the next field.
Only valid frequencies will be operable.
If you want to operate this channel as a
receive-only channel, press the [CLR] key
(setting the display to 0.0) followed by the
[ENT] key. The transmitter will be locked off
for this channel.
5. Transmit Guard
After the TX FREQUENCY is set, the ‘TX
GUARD’ field appears. This is the Code
Guard value for Channel 1 transmit (0.0
indicates ‘no guard’). If this value is correct
press the [FCN] key to advance to the next
field. To enter a new value, press the [CLR]
key to reset the display to 0.0. Press the
number keys to enter a Tone Code Guard
value. See "Tone Code Guard Values" on
page 22 of this manual.
PROG RX CG
D 023
Rx Guard
PROG TX
148.00000
Tx frequency
PROG TX CG
100.0
Tx Guard
Keypad Programming Manual 17
Press the [PRI] key to cycle through the
priority group options, or press number keys
to enter a group.
Press the [ENT] key to store the new priority
group and advance to the next field.
10. Priority 2 Channel
After the Priority 1 Group is set, the ‘Priority
2 Channel’ is displayed. Any one of the 500
channels in the radios can be designated as
the Priority 2 channel, or PR2 can be tied to
the Channel Selector knob, or programmed
OFF.
The PR2 channel cannot be altered during
normal radio operation.
Press the [PRI] key to cycle through the
priority channel options.
Setting the channel to MAIN ties the PR2
channel to the Channel Selector knob.
Press the [ENT] key to store the new priority
channel and advance to the next field.
11. Priority 2 Group
If the Priority 2 channel has been
programmed as one of the 500 channels in
the radio, the group where the channel
resides must be designated. If PR2 has
been tied to the Channel Selector knob (set
to MAIN), or programmed OFF, the Priority
Group field is skipped.
Press the [PRI] key to cycle through the
priority group options, or press number keys
to enter a group.
Press the [ENT] key to store the new priority
group and advance to the next field.
PROG
CHANNEL 12
PRI-2 CHAN
PROG
GROUP 2
PRI-2 GROUP