Specifications

18 BK Radio
12. Old-Style BK Priority Scan
The radio can be programmed to mimic the
Old-Style BK Priority Scan Modes as follows:
Mode PR1 TX on PR1 PR2
A Main No Off
B Fixed Channel # No Off
C Fixed Channel # Yes Off
13. Review Global Parameters (GRP 00)
Press the [FCN] key repeatedly to display
each setting in GRP 00, and then return to
the GRP 00 starting point.
E. EXIT PROGRAMMING MODE
1. Rotate the OFF-VOL knob counterclockwise
to the OFF position.
2. The radio will be in normal Operating Mode
the next time it is turned on.
CLONING RADIO SETTINGS
Any “Master” radio (a GPH-CMD with the desired radio frequencies
and settings) is capable of transferring its program to another GPH-
CMD or GPH radio. The radio receiving the program is referred to as
the “Slave” or “Clone.” The LAA0700 cloning cable will be required in
the following procedure.
Data that can be cloned to another GPH-CMD
radio includes:
 Group data
 Command Group data
 Global data
 UTXG Pick List
Keypad Programming Manual 7
1. Channel Bandwidth
Press ‘1’ and the display will show ‘PROG
CH 01’. This is the starting point for entering
channel 1 values.
At this point, pressing the [#] key will toggle
the channel's bandwidth setting. An 'N' will
appear to the right of the channel number
when the channel is set for 12.5/15 kHz
channel spacing using the narrow band
receiver filter. A ‘W’ appears when the
channel is set for 25/30 kHz channel spacing
using the wide band receiver filter.
2. Receive Frequency
Press the [FCN] key to move to the ‘RX
FREQUENCY’ field. This is the receive
frequency for channel 1 (in MHz).
If the displayed frequency is correct, press
the [FCN] key to advance to the next field.
If a new frequency is desired, press the
[CLR] key followed by the digits of the
desired frequency. Then press the [ENT] key
to store this frequency and automatically
advance to the next field.
3. Receive Guard
After the RX FREQUENCY is set, the ‘RX
GUARD’ field appears. This is the Code
Guard value for Channel 1 receive.
NOTE: 0.0 indicates carrier squelch
operation (no Code Guard).
If the displayed value is correct, press the
[FCN] key to advance to the next field.
If a new value is desired, press the number
keys 0 thru 9 to enter a Tone Code Guard
value. See "Tone Code Guard Values" on
page 22 of this manual.
PROG
CH 01 N
PROG RX
148.00000
rx frequency
PROG RX CG
000.0
rx guard