Specifications

6 BK Radio
2. Group Label
After Group Options, the display will show
the label for the Channel Group. Each
Channel Group can have a label of up to
twelve characters or spaces. The characters
can include 0-9, A-Z, –, -, ., *, +, <, >, /, \, |,
$, %, h, or blank.
If no change is needed, press the [FCN] key
to go back to the starting point for Channel 0
settings.
NOTE: Special software available from BK
Radio lets you enter Group Labels and
Channel Labels from a computer. Contact
your dealer for information.
Changing The Group Label
Labels are edited from left to right. Pressing
the [PRI] key moves the cursor to the next
character. Pressing and holding the [PRI]
key backspaces to the previous character.
The number keys 2 – 9 allow for entry of the
letters printed on the respective keys. For
example, the first press of the [2] key enters
the letter A, the second press enters a B, the
third press enters a C, and the forth press
enters a 2. The letters Q and Z are entered
with keys 7 and 9.
Keys 0 and 1 can be used to enter the
following characters:
0: 0, space, –, _, ., *, +
1: 1, <, >, /, \, |, $, %, h
Press the [ENT] key to store changes and
go back to the starting point for Channel 0
settings.
C. CHANNEL PARAMETERS (CH 01 - 20)
At the starting point for Channel 0, the display shows ‘PROG CH
00’. At this point, a channel number can now be entered to allow
access to the frequencies and Code Guard values for that
channel.
PROG
LABEL 1
GROUP LABEL
Keypad Programming Manual 19
Master
Clone
Master
Switch
When the Master’s Command Group is cloned
to a slave, the channel data that is ‘pointed to’
by the Command Group is transferred to a
target group (not the Command Group) in the
slave. The target group’s label in the slave will
be set to “CMND CLN”.
Data that can be cloned to a standard GPH
radio includes:
 Group data
 Command Group data
When cloning to a GPH radio, the Master’s
global data is converted to group data in the
slave, and only the first 16 channels are
transferred.
When receiving an incoming clone from a GPH
radio, the GPH-CMD radio ignores group data
other than the group label and the group scan
list bit. The GPH-CMD’s global data and
channels 17-20 are not disturbed.
NOTE: Some groups may be “locked” by PC
programming to prevent them from being
overwritten. Only “unlocked” groups will accept
incoming clones.
1. Make sure the battery packs for both radios
are charged.
2. Attach the master switch end of the cloning
cable to the side connector of the Master
radio.
NOTE: One plug of the cloning cable has a
push-button master switch. This plug must
be attached to the Master radio.
3. Turn on the Master radio.
4. Put the Master radio in Programming Mode
by pressing and holding the master switch
then pressing and holding the [FCN] key
until the display shows ‘PSWRD-******’.
Enter the 6-digit password. The display
shows ‘PROG CH 00.’
CMND CLN
PSWRD-******
PROG
ch 00