Specifications

4 BK Radio
1. Group Parameters (CH 00) include:
 Group Options:
1-12345678
(1-7 = undefined, 8 = group scan list bit)
 Group Label
To edit channel data, at the CH 00 prompt
enter the number of the channel to be
programmed, or press the [PRI] key to
increment to the desired channel. Press the
[FCN] key repeatedly to cycle through the
data fields, and then loop back to the CH
entry point.
2. Channel Parameters (CH 01 - 20) include:
 Bandwidth
([#] key at CH prompt toggles Wide/Narrow)
 RX Frequency
 RX CxCSS
 TX Frequency
 TX CxCSS
 Channel Label
To edit global data (GRP 00), press and hold
the [#] key at any CH prompt to get the
group selection prompt. Enter ‘0’ to select
global data. Press [FCN] to access the data.
Press the [FCN] key repeatedly to cycle
through the data fields, and then loop back
to the GRP 00 entry point.
3. Global Parameters (GRP 00) include:
 Keypad Programming Password
 Global Options 1:
Battery Saver, TX on PRI1, PRI1 Lock,
Scan List Lock, Backlight Triggers, Beep
Disable
 Global Options 2:
Busy Channel Mode, ANI/DTMF Mode
 ANI ID
Keypad Programming Manual 21
10. If the download was successful, the display
on the Master will again display the clone
prompt (target and data to be transferred).
• To clone another channel group, press the
Master radio’s [CLR] key. Navigate to a
‘CH’ prompt, then press and hold the [#]
key to get the ‘GRP’ prompt.
• If cloning is finished, turn off the Clone
and disconnect the cloning cable. Normal
radio operation will occur when you turn
on the Clone.
11. If the download was not successful, the
master will flash ‘FAILURE’ and multiple
beeps will follow. Failure of downloading can
be due to:
• Improper connection
• Failure to turn on the clone
• Setting the clone in Programming Mode
• Target radio’s group ‘locked’ by PC
Programming
NOTE: To stop the ‘FAILURE’ Mode,
press [CLR], turn off both radios,
and try again, starting with Step 1
on the previous page.
1 2 3
4
5 6
7
8 9
0
*
#
CLR
FCN
PRI
ENT
FAILURE
Group 01