Specifications

14 BK Radio
Options 6–8: Reserved For Future
Options
Once each option is set as desired, you can
store the changes, discard the changes, or
disable all displayed options.
Press the [CLR] key to disable all displayed
options (steady).
Press the [ENT] key to store new displayed
options settings into memory and advance to
the next field.
Press the [FCN] key to advance to the next
field without saving changes.
4. Automatic Numeric Identification (ANI)
After the Global Options are set, the display
will indicate the ‘ANI ID’ number (as many as
seven digits may be used). The ID number
can be used for either radio management or
transmitted as a DTMF tone burst for ANI
purposes. The ANI can be enabled or
disabled. See “ANI/DTMF Mode” on the
previous page.
If no change is needed for the ID number,
press the [FCN] key to advance to the next
field.
A new number can be entered by pressing
number keys. The digits will appear at the
right of display and move to the left. Press
the [ENT] key to store the new ID number
and advance to the next section.
The existing ID number can be incremented
one digit by pressing the [PRI] key.
Press the [ENT] key to store the new ID
number and advance to the next field.
5. Transmitter Time-Out Timer
After the ID number is set, the ‘Transmitter
Time-Out Timer’ field is displayed. 0 SEC
means the Time-Out Timer is disabled.
Press the [PRI] key to increase the Time-Out
Timer duration by 15 seconds, with a
maximum of 225 seconds (3 minutes, 45
PROG ID
ANI 1234567
Ani id num
PROG TX
225 sec
tx timeout
Keypad Programming Manual 11
Option 3: Transmit On Priority 1
When Option 3 is enabled (flashing),
transmissions will occur on PR1 (if PR1 isn’t
programmed OFF) when operating in Single
or Dual Priority Scan Mode. To simulate BK
Radio’s Old-Style Priority Mode C, Transmit
on Priority 1 must be enabled.
Option 4: Priority 1 Lock
When Option 4 is enabled (flashing) the user
will not be able to change the designation of
the Priority 1 Channel by selecting a channel
and pressing the [PRI] key.
When Option 4 is disabled (steady) the user
will be able to change the channel that is
designated as Priority 1 Channel.
Option 5: Scan List Lock
When Option 5 is enabled (flashing), the
user will not be able to use the [ENT] and
[CLR] keys to add channels to and delete
channels from the Scan List.
When disabled (steady), the user can alter
the Scan List using the [ENT] and [CLR]
keys.
Option 6: Backlight On Display Change
When Option 6 is enabled (flashing), the
display backlight will illuminate each time the
display receives input. This includes
displayed changes in the selected channel
or scan channel, and the PR, TX, and SCN
annunciators. The display will not illuminate
if Backlight Duration is set to LITE OFF.
See "Backlight Duration" on page 15 of this
manual.
PROG
1-12345678
GBL OPTIONS
PROG
1-12345678
GBL OPTIONS
PROG
1-12345678
GBL OPTIONS