Specifications

Schematic Menu Commands 199
D0..15 AS* UDS* LDS*
CLK FC0..3 MEMOP BRQ0..2
Pin Spacing
The number in the Pin spacing box will be the spacing between signal pins
on the breakout symbol, in grid units. The default value is 4 to match the
standard LogicWorks libraries, but any number from 1 to 100 can be
entered.
Push Into
This command opens the internal circuit of the given device in a separate
window. This menu item will be disabled (gray) under any of the following
conditions:
 The device is not a SUBCCT (subcircuit) primitive type, or has no
subcircuit.
 The device has its “restrict open” switch set in the Device Info box.
Simply double-clicking on a device is a shortcut for the Push Into com-
mand.
NOTE: If you have used the same device type in multiple places in the design, the
Push Into command creates a temporary type which is distinct from all
other usages. When the subcircuit is closed, the other devices of the same
type will be updated.
NOTE: See Chapter 6, Advanced Schematic Editing, for more information.
Pop Up
This command closes the current subcircuit and displays the circuit con-
taining the parent device. If any changes have been made to the internal cir-
cuit that would affect other devices of the same type, the other devices will
be updated with the new information.
LW Reference.bk Page 199 Monday, December 15, 2003 5:59 PM