Specifications

138 Chapter 8—Device Symbol Editing
 Make sure the source and destination libraries are open in the Parts
palette. If not, follow the steps under “Manually Opening a Library”
on page 136.
 Select the Lib Maintenance command, either in the Libraries sub-menu
of the File menu, or by holding the š key pressed while clicking in the
Parts palette.
 Select the source library in the pop-up library selection menu above the
“Source Lib” list.
 Select the destination library in the pop-up library selection menu
above the “Dest Lib” list.
 Select the symbols to be copied in the source list. You can select
multiple items using the and keys.
 Click the Copy button.
The copy operation will now proceed, with status messages appearing in the
Messages area at the bottom of the box.
Copying Symbols from a Design to a Library
See “.Saving a Symbol Definition from a Schematic to a Library” on page 141.
Deleting Symbols from a Library
One or more symbols may be permanently deleted from a library by following
these steps:
 Make sure the target library is open in the Parts palette. If not, follow
the steps in “Manually Opening a Library” on page 136.
 Select the Lib Maintenance command, either in the Libraries sub-menu
of the File menu, or by holding the š key pressed while clicking in the
Parts palette.
 Select the target library in the pop-up library selection menu above the
“Source Lib” list.
 Select the symbols to be deleted in the source list. You can select
multiple items using the and keys.
LW Reference.bk Page 138 Monday, December 15, 2003 5:59 PM