Specifications

Timing Window Editing 93
Deselecting
Clicking anywhere in the trace area that is not in a trace will deselect the
labels and selection interval.
Clicking in the label area above or below the label list deselects all traces
but leaves the current interval selected.
Summary of Timing Edit Commands
The following table summarizes operation of the Timing edit commands in
the Edit menu.
 See Chapter 12, Menu Reference, for a detailed description of these
commands. See Appendix D, Timing Text Data Format, for a
description of the Clipboard data format.
NOTE: 1) If you wish to paste a timing picture into a word processing package, it
may be necessary to first paste it into a drawing program to extract the
picture data from the Clipboard, or to use a Paste Special command (if the
destination program has one) to select the picture format. A word
processing package will, by default, normally take the text data from the
Clipboard.
Copy The Copy command copies the selected timing data to the
Clipboard in picture and text format. See the notes under the Cut
command, above. Note that Copy can be used on a selection to
the left of (older than) the current simulation time since it does
not modify the selected data.
Paste The Paste command pastes the text timing data from the
Clipboard onto the selected area of the Timing window. The
selected time interval is deleted and then the new data is inserted.
That is, data following the selection interval will be moved
forward by the width of the selection interval, then back by the
width of the pasted data.
LW Reference.bk Page 93 Monday, December 15, 2003 5:59 PM