Specifications

Timing Window Editing 91
 To set the selection interval, click and hold down the mouse button in
the time scale at either end of the desired interval. Drag left or right
until the desired interval is enclosed. When the mouse button is
released, the select interval is set, and two selection interval lines will
appear. If any of the signal labels were selected, the timing signal
within the selected interval will be highlighted in the Timing window.
NOTE: Clicking and releasing the mouse button at one spot will create a zero–width
interval. This can be used to insert Pasted data without deleting any existing
data.
Drag Selection
This method allows you to select a group of labels and a time interval in a
rectangular area of the Timing window.
To do a drag selection, click and hold the mouse button at any corner of the
rectangular area you wish to select. Drag diagonally across the desired
area. When the mouse button is released, the enclosed time interval and
traces will be selected.
LW Reference.bk Page 91 Monday, December 15, 2003 5:59 PM