Specifications

B&K Components Device Interface Protocol (BKC-DIP) Specification
Version 2.01.00
Updated 01/24/07
Page 41 of 54
Ttt where tt * 100ms is the timeout before the display is cleared, and T00 indicates
the display should not timeout. Valid tt values are from 00 (no timeout) to FF
(25.5 seconds).
Xcc where cc is the column where the text is positioned
Yrr where cc is the row where the text is positioned
Text may be displayed and positioned on the Front Panel Display using the following display
message:
(0, d, f, t0, x0, y2, "Testing";0756)
where
0 receive ID, text will only be displayed on the Front Panels of units with receive
IDs of 00h
t0 indicates the display will NOT be clear by a timeout
x0 indicates the displayed text will start at row 00h (the first row)
y2 indicated the displayed text will start at column 02h (the third column)
NOTE: T00 indicates text will not timeout.
NOTE: The X and Y coordinates are zero based. Currently, the Front Panel Display dimensions
are 16 characters by 1 character.
NOTE: Valid screen FP coordinates are 00h to 0Fh by 00h.
NOTE: The B&K Component's device has priority over its Front Panel Display. Thus, system
events can overwrite BKC-DIP displayed text. For example:
(0, D, F, T00, X0, Y0, "No Timeout";07CA)
The text will appear on the Front Panel Display. If, however, the user then changes the volume,
the FP will be overwritten with the volume information.
LED display: (receiveID, D, L, Ttt, n=bitmap; cs16)
B&K Component units' front panel LEDs may be individually controlled.
Ttt where tt * 100ms is the timeout before the display is cleared, and T00 indicates
the display should not timeout. Valid tt values are from 00 (no timeout) to FF
(25.5 seconds).
n indicates which LED buffer
bitmap indicates which of the LEDs are active (1 = active, 0 = inactive)
NOTE: T00 indicates LEDs will not timeout.
For example, to activate the DOWN LED and the REAR LEVEL LED, send the following
command:
(00, D, L, T00, 1=21; 0360)
1 LED Buffer 1
21h 01h (the DOWN LED) + 20h (the REAR LEVEL LED)
NOTE: Due to the front panel electronics, only one of each of the following electrical banks of