Specifications

B&K Components Device Interface Protocol (BKC-DIP) Specification
Version 2.01.00
Updated 01/24/07
Page 16 of 54
Cold Boot Command: (receiveID, X, 6; cs16)
(0,X,6;cs16) Cold Boot BKC-DIP device
Factory Reset Command: (receiveID, X, 7; cs16)
(0,X,7;cs16) Factory Reset BKC-DIP device
WARNING!: Issuing a Factory Reset Command will destroy all user
modified data in the unit (preset, system settings, etc.).
Reinitialize BKC-DIP State Command: (receiveID, X, 8; cs16)
(0,X,8;cs16) Reinitialize BKC-DIP State parameters
Test Tone State Command: (receiveID, X, 9, level; cs16)
(0,X,9,2;cs16) Test Tone on at –30.0 dB level
(0,X,9,0;cs16) Test Tone off
Mute State Command: (receiveID, X, A, z=muteState; cs16)
(0,X,A,1=1;cs16) Mute Z1
(0,X,A,2=0;cs16) Unmute Z2
B&K Device to Host Commands Summary
E (echo) Command
(2, E, G, P1=00, 0228;0393) Echo from unit 02h for Get Z1 Preset 0 command
R (reply) Command
(2, R, P2=1,3=5;02D8) Reply from unit 02h Z2 Preset 1 parameter 3 info
(0, R, D, F, 0="X FRONT PANEL XX ",80=1;cs16)
Reply from the Get Display command (transmitID, G, D, d; cs16)
U (update) Command
Status message: (transmitID, U, S, 0=“BKC-DIP ACTIVE”;cs16)
(0,U,S,0=”BKC-DIP ACTIVE”;cs16) Ready for BKC-DIP commands
IR message: (transmitID, U, I, z=ir;cs16)
(0,U,I,1=C4;cs16) Update to host from Zone 1 <Volume ->
Front Panel message: (transmitID, U, F, z=ir;cs16)
(0,U,F,1=A;cs16) Update to host from Zone 1 front panel <Volume ->
Realtime Status message: (transmitID, U, R, identifier=value;cs16)
(0,U,R,5=sample rate;cs16) Update from sample rate change