Owner`s manual

BANKER MESSAGES INDEX:

 Scoop On – When the BANKER has been turned OFF and ON, Scoop On will be displayed

on the first Coin Denomination. Place an Empty Till Cup on the Platter and three Zeros

(000) should appear on the bottom of the display. Remove the Till Cup and UP or DOWN

arrow to the appropriate denomination to start counting.

 Scoop Only – The Empty Till Cup that is being used is different than the Tare Weight that

is programmed in the BANKER. Try a different Till Cup. If the display will not clear, call

BANKER Support.

 Short Roll & a Beep – Will display when counting Rolled Coin; Roll is Short Coin (s).

Place the same amount of coin(s) on the Banker platter as needed to complete the roll

and add to roll.

 Try Less – When counting loose currency, more than 18 loose bills have been placed

on the platter. Remove a few of the bills until what has been placed on the platter has

been counted, Positive Beep should be heard. Place the next bunch of the same

currency on the platter, until all has been counted. May also be displayed when

counting “Clips” of money. Number of Bills in Clip is incorrect. Remove Paper Clip and

count as Loose Currency.

 Over Range – When counting Rolled Coin or Currency, remove the last Roll of Coin or a

few Bills until ERROR disappears. Remove all the Roll Coin or Currency and what has

been counted so far and it will print. Continue back to same Currency Denomination

or Roll Coin and complete process.

 SUSPECT - When counting Packs of Money, Pack is Suspect, Short or Over Pack $

amount. Remove Bank Strap or Rubber Band and count as loose currency. If pack is

correct, then Pack Programming may be needed.

 Printer Error – Check both ends of Printer Cable to make sure that they are

completely plugged into the correct connector. - Check Printer Power On/Off Switch

to make certain that the switch is in the “ON” position.