Owner`s manual

STEP FOUR (4): Connect Printer Cable to the printer and to the Banker BK-10.

Citizens Thermal Printer Model CT-S280

Installation Instructions

1. Turn the BANKER OFF

2. Plug the Power Connector End into the BANKER First, than the Electrical Plug into

Leveler power protection device as shown in steps two(2) and three(3).

3. Install the Printer Cable into the Printer & BANKER:

To Printer End – Plug 24 Pin Connector and Power Connector into the rear of Printer.

To Counter End –Plug the 24 Pin Connector into the Printer Port; Back of BANKER.

4. Load MaxStick Label Printer Paper into the Printer, by depressing the Printer Lid Release

button on the Right Side of the Printer. Note: The Paper Roll should be dropped into

the Printer with the Paper unrolling from the Bottom of the Roll and placed over the

Top of the Print Head. Close the Lid until a click is heard.

5. Turn the BANKER ON and make sure that the Printer’s Power Switch, on the Lower Left

bottom side of the Printer, is in the ON Position. (White Dot Down). The Green Power

Light should be ON.

6. The Printer is now ready for use.

STEP FIVE (5): Plug the Leveler Power protection device into the available AC power source:

CAUTION: NEVER USE A SURGE STRIP AS AN OUTLET POWER SOURCE WITH THE LEVELER DEVICE.

AC inverter

(optional not

included in kit)