Banker BK-10 Kit Manual Team One Repair, Inc. 1911 Satellite Blvd. Suite 100 Buford, GA.
TABLE OF CONTENTS Banker BK-10 Introduction and Contents………………………………………………………..Page 3 Installation and Set Up Guide (5 easy steps)…………………………………………….
Thank you for your purchase of the Banker BK-10 kit. Your kit includes the following: One (1) Banker BK-10 Money counting and dry weight measurement machine. Five (5) Till Cups for coins One (1) Instruction/ Operations guide on DVD for the Banker BK-10 One (1) Power Supply/Ac cord for the Banker BK-10 and Citizen Printer One (1) Citizen Printer One (1) Citizen Printer Owner Manual Also review the Operations guide for the printer included in this document.
Installation and Set-Up Guide STEP ONE (1): Remove all products from the carrying case and place them on a flat surface as shown STEP TWO (2): Plug provided power supply into the Leveler power protection device as shown Extra outlet. Only to be used with approved Banker accessories. Contact us for details. STEP THREE (3): Now insert the two cords shown with arrows into the back of the Citizen Printer and the other end of the cable into the back of The Banker money counter. See details next step.
STEP FOUR (4): Connect Printer Cable to the printer and to the Banker BK-10. Citizens Thermal Printer Model CT-S280 Installation Instructions 1. Turn the BANKER OFF 2. Plug the Power Connector End into the BANKER First, than the Electrical Plug into Leveler power protection device as shown in steps two(2) and three(3). 3. Install the Printer Cable into the Printer & BANKER: To Printer End – Plug 24 Pin Connector and Power Connector into the rear of Printer.
BANKER BK-10 OPERATIONS GUIDE (Be sure to view the enclosed DVD video on how to operate The Banker) Key in Cashier #, Manager # or Lane #, etc. and depresses the P Key one time after each entry. Verify that the BANKER display is at the 1c (Penny) Prompt. NOTE: If not, use the up Arrow or down Arrow key to get to the 1c Prompt Place the Till Cup with the loose Pennies on the Bankers Platter. Wait for the “beep” and display will show the count of Pennies in the Till Cup.
CURRENCY DENOMINATIONS: 1c = Pennies 1- = Rolls of change and Singles 5c = Nickels 5- = Five $ bills 10c = Dimes 10- = Ten $ bills 25c = Quarters 20- = Twenty $ bills 50- = Fifty $ bills 100- = One hundred $ bills The BANKER should remain “ON” at all times during count operations. If it is turned off and turned back on, the following prompt will be displayed: “SCOOP ON” Place an empty Till Cup on the platter. This verifies the Tare Weight of the empty Till Cup.
BANKER MESSAGES INDEX: Scoop On – When the BANKER has been turned OFF and ON, Scoop On will be displayed on the first Coin Denomination. Place an Empty Till Cup on the Platter and three Zeros (000) should appear on the bottom of the display. Remove the Till Cup and UP or DOWN arrow to the appropriate denomination to start counting. Scoop Only – The Empty Till Cup that is being used is different than the Tare Weight that is programmed in the BANKER. Try a different Till Cup.
BANKER PROGRAMMING & OPTIONS: DATE & TIME PRINT ON RECEIPT TAPE Press key immediately after turning on Banker. Follow Display Prompts below: Banker will respond with "Enter Date" and next "Enter Time". Example: Date - June 8, 2007 ……. Enter as “060807” Example: Time - 1:30 pm ……..Enter as “0130”, then….AM enter “ 0” , or PM enter “1” PROGRAM FOR PACKS OF CURRENCY: Press Z key immediately after Turning On the Banker. Press keys to select denomination to be programmed.
MaxStick PAPER RE-ORDER/REPLENISHMENT Available from stock for rapid delivery 6 rolls per box Order by Email: sales@teamonerepair.com Order by Phone: 678-985-0772 Order (Government orders) at GSA Advantage: www.gsaadvantage.gov Most Major credit cards accepted including Government issued credit cards For more information on Maxstick products visit: www.maxstick.com BK-10 KIT WARRANTY SERVICE & REPAIR CONTACT INFORMATION ADDRESS: Team One Repair, Inc.
