User Manual

1-3
2.12 Parallel Mode Setting ...................................................................... 32
2.12.1 Error Message of Parallel Connection ....................................... 34
2.13 External Analog Interface ................................................................ 36
2.13.1 Analog Interface Pin Assignment .............................................. 36
2.13.2 Functions .................................................................................... 37
2.14 Programmable Sequence Mode (List mode) ................................... 48
2.15 Multi-unit Connection Mode (RS485) ............................................ 54
3. Protection and Error Messages............................................................ 54
3.1 Overvoltage Protection (OVP) ........................................................ 54
3.2 Overcurrent Protection (OCP) ......................................................... 55
3.3 Overpower Protection (OPP) ........................................................... 55
3.4 Constant Voltage Protection (CV TO CC) ....................................... 55
3.5 Constant Current Protection (CC TO CV)....................................... 56
3.6 Overtemperature Protection (OTP) ................................................. 56
3.7 Low Voltage Protection (ACD) ....................................................... 57
3.8 Input Error Message ........................................................................ 57
4. Remote Communication ....................................................................... 58
4.1 Interface Connection ....................................................................... 58
4.2 Parameters Definition ...................................................................... 63
4.3 The Error/Event List ........................................................................ 65
4.4 Remote Communication Protocol ................................................... 66
4.5 SCPI Conformity Information ......................................................... 69
4.5.1 Common SCPI commands ......................................................... 69
4.5.2 SCPI Command subsystem ........................................................ 70
4.6 State Bit Definition .......................................................................... 81
4.7 Multi-Unit Programming Commands .............................................. 82
4.7.1 System Control Commands ....................................................... 82