User Manual

1-79
Using Telnet
The power supply can be controlled via Telnet over the Ethernet interface.
Simply go into command prompt under MS-DOS and enter: Telnet
<DeviceIP> 5024 (<Device IP> is IP address of the unit; 5024 is the
Telnet port). A welcome message will be shown as below:
Input SCPI command to communicate with the system, such as below:
Using Sockets
All XLN series use port 5025 for remote communication via socket
connection using the LAN interface. Socket connection uses the TCP/IP
protocol. Be sure Suppress End On Reads is disabled.