User Manual

1-38

To set a XLN3640/XLN6024/XLN8018/XLN10014 to slave mode, press

, and

in the main screen to enter the series/parallel

setting option. And then select the parallel mode by turning the knob (SCPI

command is “PS:MODE PARALLEL”) and then press to confirm. It

will continue to the next line for the MASTER/SLAVE selection. Turning the

knob to select SLAVE A (SCPI command is “PS:TYPE SLAVEA”) for the

supply and press to confirm the setting. Using the same procedure,

setup SLAVE B and C for another two (2) supplies as shown below.

To set the master unit, press

, and

in the main screen to

enter the series/parallel setting option. And then use the knob to select the parallel

mode (SCPI command is “PS:MODE PARALLEL”) and press to

confirm. It will continue to the next line for the MASTER/SLAVE selection. Use

knob again to select MASTER (SCPI command is “PS:TYPE MASTER”) and

then press to confirm. After it is confirmed as the Master the

XLN3640/XLN6024/XLN8018/XLN10014 will start searching for all Slaves, as

shown below:

If wiring is correct, screen will appear as:

After receiving the control command from the Master, all Slaves will be locked

LLL=

= LL

= LL L

F L

...

= LL L