User Manual

85
4.7.2 Output Control Commands
This set of commands controls the outputs of the selected instrument
(based on their address). Use CADR command (described in previous
section) first to select the address of the unit you want to control before
using any of these commands to control that unit’s output.
Command Description
==================================================
CPV Sets the output voltage value in Volts
CPV? Reads the output voltage setting
CMV? Reads the actual output voltage
CPC Sets the output current value in Amperes
CPC? Reads the output current setting
CMC Reads the actual output current
CDVC? Display voltage and current data
COUT Turns the output to ON or OFF
COUT? Returns the output On/Off status
COV Sets the OVP level
COV? Returns the OVP setting level
COVP Sets the OVP on/off
COVP? Returns the OVP on/off
COC Sets the OCP level
COC? Returns the OCP setting level
COCP Sets the OCP on/off
COCP? Returns the OCP on/off
COP Sets the OPP level
COP? Returns the OPP setting level
COPP Sets the OPP on/off
COPP? Returns the OPP on/off
CMODE? Returns the power supply operation mode
==================================================