User Manual

55
system will enter the “Overvoltage Protection” mode that will shut off the output
and show OVP on the display. Press ESC to reset the protection mode and
deactivate the the buzzer.
3.2 Overcurrent Protection (OCP)
When OCP is activated and the current measured exceeds the set point of
protected current, system will enter the “Overcurrent Protect” mode that will shut
off the output and show OCP on the display. Press ESC to reset the protection
mode and deactivate the buzzer.
3.3 Overpower Protection (OPP)
When OPP is activated and the power measured exceeds the set point, the system
will enter the “Overpower Protection” mode that will shut off the output and
display OPP on the screen. Press ESC to reset the protection mode and deactivate
buzzer.
3.4 Constant Voltage Protection (CV TO
= .
.
= .
.
FF
1 1
= .
.
= .
.
FF
1 1
= .
.
= .
.
FF
1 1