User Manual

45
EXTERN VOLT CONTROL= VOLT
EXTERN CURR CONTROL= VOLT
EXTERN PROGRAM= 10 V / 10 K
Under voltage control, you may input s DC voltage through Pin 10 to
control the power supply’s output current value.
13 246 579 81012 1113
1416 151719 182022 212325 24
DC SOURCE
+
-
You may access MENU 6-SPECIAL TEST FUNC  2. EXTERNAL
CONTROL to choose the input voltage range at [EXTERN PROGRAM] to
[10 V / 10 K] for 0 – 10V and [ 5 V / 5 K] for 0 – 5V.
EXTERN VOLT CONTROL= VOLT
EXTERN CURR CONTROL= VOLT
EXTERN PROGRAM= 10 V / 10 K
Current Program – Resistor Mode
This function allows you to program the current output by connecting a
resistance to Pin 10. For this function to be enabled, the output control
must be set to Analog mode. The external resistance range used to control
the full scale of the output voltage can fall into the 0 – 10 kΩ or 0 – 5 kΩ
range. Then access MENU 6-SPECIAL TEST FUNC  2. EXTERNAL
CONTROL to set [EXTERN CURR CONTROL =] to [RES], as shown in
the figure below.