User Manual

If more than one Master is being set to parallel mode, the following message will

be displayed.

After the master is configured, if it cannot communicate with one of the slave

supplies, the following error message will be displayed (example showing Slave

After finishing the set up, if a Slave receives only the output command sent by

the Master but does not receive the synchronization signal, it will present the

following error messages. The error message “SYNC ON” is shown when the

slave is not receiving the synchronous output ON signal. The error message

“SYNC OFF” is shown when the slave is not receiving the synchronous output

OFF signal.

F L

=FF

L =

=FF

!!!

LL L