User Manual

24
overvoltage protection
protection point.
OCP: Enables/disables
overcurrent protection
SET: Set up the overcurrent protection
point.
OPP: Enables/disables overpower
protection
SET: Set up the overpower protection
point.
CV TO CC:
Enables/disables the protection of the change
from CV to CC mode
CC TO CV:
Enables/disables the protection of the change
from CC to CV mode
4. PARALLEL SETTING
Press in the second screen of the menu to enter PARALLEL menu.
ON/OFF:
Enables or disables the parallel
mode.
MASTER/SLAVE:
Refer to “Parallel Setting” section for
the detailed setting procedure to use
MASTER/SLAVE mode.
Note: Up to four power supplies of the same models may be
connected in parallel.
FF
FF
=
=
LT
FF
=
=
T
FF