User Manual

10
temperature is over 40
o
C; undo the operation only after the ambient
temperatures drops to the acceptable temperature range. Operating
temperature over the above range would damage the instrument.
5. This product is equipped with one blow-out type cooling fan on the
back board and three in-take cooling fans on inner side of front board.
Provide room for good ventilation near the cooling fans and keep the
boards with a space above 10 cm away from the wall. To maintain
good accuracy, do not block the ventilation holes in the front and the
rear parts of the unit.
6. Although the product is designed with filters to minimize noise from
AC power source, it is recommended that it be operated in a low power
noise environment with proper earth ground. If the power noise is
unavoidable, please install a power filter.
1.6 Storage
The storage temperature range of this product is within -10ºC - 70ºC and R.H.
should be within 80% without moisture condensing. If not operating this
product for a long time interval, pack it with original packaging or similar one
and put it in a dry place without exposure to direct sunlight.
1.7 Installing Rackmount Brackets
The power supply is designed to fit in a space of one rack unit (1U) and can be
mounted in a standard 19-inch rack panel or cabinet. Rack mount brackets must
be assembled before mounting the unit in a rack. Refer to the following figure to
assemble the rack mount brackets.
Rack mount Brackets