User Manual
Figure 5.7
–
CC Calibration of External Current Diagram
2.
Select the
EXT CURRENT CC
parameter in the
Calibration
menu and press
. The following will
be displayed:
The P: 1/4signifies there are 4 points to be calibrated and the current calibration
point is 1.
The four points use 0Ω, 2.5kΩ, 7.5kΩ, 10kΩ.
6.
Press , the calibration will start, if the resister is not insert or not correct,
the following
will be displayed:
7.
If the resister is correct,
the following will be displayed,
press .
8.
Repeat this procedure by entering the meter readings for points 2 – 4.