User Manual

Slave Unit
When a power supply is set up to be a slave unit, it will wait for the master’s connection, as shown
below.
If the master unit has found the slave unit, the slave unit will be controlled by the master unit and the
following will be displayed:
In parallel mode, the slave unit is remote controlled by the master unit. The keypad will be locked.
To exit the parallel mode, press key to access the parallel mode ON/OFF setting in the menu.
Turn off to disable parallel mode control.
3.6.1 Master Unit
After all of the slave units have been set, the master unit can be set by the same procedure with the role
set to MASTER . As shown below, the master unit will start to search for the slave units.
After the search, the master will show how many slave units have been found, as shown in the
following display:
The search is completed will go into parallel mode operation. The
following screen should be displayed.