User Manual

searching for all Slaves that are connected to the Master. To operate correctly, the user must set

the Slaves before the Master. Follow the steps below to set a supply to master or slave mode

(Note: Multi-unit connection (chain) mode will be cancelled).

1 Press the button and press the button one time until PARALLEL is select and

press .

2 Press to select the parallel MODE.

3 Use the rotary knob to select the setting of OFF or ON and press .

4 Press button one time until Address is select and press .

5 Use the rotary knob to set the master or slave and press . Use the same procedure to

set up MASTER, SLAVE 1, SLAVE 2,…,SLAVE 49 for the other power supplies.

6 Press several times to exit the menu setting.