User Manual

2. Press button one time until PROTECT is select and press . The display will then show
OVP.
3. Press button one time until OCP is displayed, and press .
4. Use numerical keys directly or use keys with rotary adjustment followed by to
confirm the OCP value.
5. Press several times to exit the menu setting.
When OCP protection is tripped during operation, the output will turn off and the following OCP status
message will display:
To clear the trip status, press once.
3.4.3 Configure Over Power Protection (OPP)
The MR overpower protection continuously monitors the output power level. If it is greater than
the OPP setting, it turns off the power supply output to protect the device under test.
Follow the steps below to set the OPP limit:
1. Press button , select CONFIGURATION , then press .
2. Press button one time until PROTECT is select and press . The display will then show
OVP.
3. Press button two times until OPP is displayed, and press .
4. Use numerical keys directly or use keys with rotary adjustment followed by to
confirm the OPP value.
5. Press several times to exit the menu setting.
When OPP protection is tripped during operation, the output will turn off and the following OPP status
message will display: