User Manual

Follow the steps below to check voltage output with no load connected.
1. Turn ON the power supply. The display will show the OFF annunciator above the voltage
display.
2. Enable the output by pressing , and the LED next to the button will be lit. The OFF
annunciator will change to CV.
3. Using the numeric keypad or the voltage adjust knob and enter a voltage value. The
voltage display will now show the value you entered. If entering with numeric keypad,
press first, then enter the value and press .
4. (Optional) You may also verify the output voltage by connecting the (+) and (-) terminals
on the rear panel to an external voltmeter. The measured value should match or be
within the entered voltage value.
2.4.2.2 Current Check