User Manual

6. Press to select NEXT parameter and use the rotary knob to select a value of 0-10. As described
previously, the user has the ability to queue another program once the current program is finished.
By default, 0 is placed as the parameter value, and represent end the program.
7. Press to select STEP_EDIT parameter , pressing , the following will be displayed:
8. As described previously, each step has the following parameters to be edited: voltage,
current, and time.
Press to edit step, use the buttons to move the cursor to the desired parameter
and use the rotary knob or keypad (numeric values only) to change the parameter values. Press
to complete the this step edit. Press to edit next step, change the step value and
continue this procedure for each step for as many steps as needed, or press several times
complete the program configuration.
9. Make sure the program is turned ON and press to exit the program settings.
10. Once the output state is enabled, by pressing , the program will automatically execute. The
following will be displayed when the program is executing: