User Manual
3.8 Power-On State
The initial Power-On state of the power supply can be configured (voltage, current, output state)
by following the steps below:
1.
From the
menu, press
button 3 times to select
POWER-ON STATE
and press
.
2.
The mode is showing on the display, press button. There are four options which can be
selected using the rotary
knob:
DISABLE
– Last voltage and current values before power off and
output state is OFF.
*RST
– Reset output settings, voltage, current, output state, slew rate.
LAST
– Last voltage, current, and output state values before
power OFF.
USER – User defined voltage, current, and output state.
3.
Select one of the settings wanted during power up, and press
to save changes. If USER has
been selected, set user defined memory and output state.
4.
Press
several times to exit the menu setting.
3.9 Communication Configuration
To set up remote interface connections and settings, refer to chapter “4
Remote Operation”.
3.10 SYSTEM Menu
All setup procedures and settings explained in this section can be
accessed from the
SYSTEM
menu.
To access this menu, press and press the button five times until
SYSTEM
is select, press
.
3.10.1 Enable/Disable Key Sound
The instrument initially has key sound enabled from factory. To disable
or re-enable the key
sound, follow the steps below:
1.
From the
SYSTEM
menu,
select
BEEP
and press
.
2.
Select between the two options using the rotary knob:
On– Enable key sound
Off – Disable key sound
3.
Select the desired option and press
to save the change.
4.
Press several times to exit the menu setting..