Owner manual

86
:POWer? Fetch the last measured power Y
TRIGger Command Summary
Commands Description Default
Channel
Specific
:TRIGger Path to program trigger layer.
[:IMMediate] Generates a trigger signal. N
:TIMer <NRf> Set timer interval (0.01 to 999.99sec). 0.1 N
:TIMer? Query the programmed timer interval. N
SYSTem Command Summary
Commands Description Default
Channel
Specific
:SYSTem
:PRESet Return to :SYST:PRESet defaults. N
:POSetup <name> Select power-on setup: (RST or SAV0). RST N
:POSetup? Query power-on setup. N
:VERsion? Query rev level of SCPI standard. N
:ERRor? Query (read) Error Queue. N
:CLEar Clears messages from the Error Queue. N
:LOCal
Take load out of remote and restore operation
of front panel controls.
N
:REMote Place load in remote control. N
:RWLock Lockout front panel controls. N
STATus Command Summary
Commands Description Default
Channel
Specific
:STATus (note 1)
:CHANnel Path to control channel status registers. Y
[:EVENt]? Read the event register. (note 2) Y
:ENABle <n> Program the enable register. (note 3) Y