Owner manual

78
Examples
PROG:STOP:COND COMP
Sets the program to stop on completion.
Query Syntax
PROG:STOP:COND?
Returned Parameters
COMPletion, FAILure
:PROGram:CHAin
The command is used to specify the program chain parameter. This specifies the next program to run
automatic testing after the current program finishes. If set to 0, no further programs will be tested and
test will end.
Command Syntax
PROGram:CHAin <n>
Parameters
<n> - Program number, 1 to 10.
Set to 0 if no programs will be tested after completion of
the current program.
Examples
PROG:CHA 3
Configures program 3 to be run following after the current
program finishes.
Query Syntax
PROG:CHA? <n>
Returned Parameters
<n>
:PROGram:SAVe
The command is used to save the configurations to a program location in memory.
Command Syntax
PROGram:SAVe <n>
Parameters
<n> - Program number, 1 to 10.
Examples
PROG:SAV 2
Saves the configurations to program 2 location.
:PROGram:RCL
The command is used to recall a specified program from memory.
Command Syntax
PROGram:RCL <n>
Parameters
<n> - Program number, 1 to 10.
Examples
PROG:RCL 2
Recall program 2 from memory.