User Manual

Check the box to enable data logging and set the desired sampling interval. The sampling

interval is displayed in seconds (s). Data logging will start when the output is enabled.

Output Timer

The output timer is used to disable the output after a certain period of time. The timer can be

set from 1 second to over 277 hours.

To enable output timer, click ‘Setting’ and the following menu will appear:

Check the box under ‘Timer setting’ to enable the timer. Set the desired time in seconds (s) and

click ‘Ok’ to confirm. The timer will start when the output is enabled.

11.4.4 Multi-Phase Application Mode

Communication Setup

After following the configuration steps in Section 3 above you can now connect the

9832B/9833B AC Power Sources to your computer using a standard USB communication cable.

Each AC Source must be connected to your computer or USB hub independently as shown:

Phase control software requires a USB COMM connection, and does not support RS232

connections.

Computer/USB hub